Eaton's 4 The Birds - Bird Repellent Gel 10 oz

USE EATON'S 4 THE BIRDS - BIRD REPELLENT GEL ON LEDGES, ROOSTS AND OTHER AREAS
WHERE PIGEONS, SPARROWS, STARLINGS, AND OTHER NUISANCE BIRDS FREQUENT !

With Eaton's 4 The Birds - Bird Repellent Gel, simply apply beads of repellent no larger than 1/2" wide by 1/2" deep at the deepest part in strips no closer than 2" apart, beginning 1" in from the outer edge with a caulking gun. Leaves a clear odorless "tacky" bead of gel that birds just hate ! Once they land on it, Eaton's 4 The Birds sticks to their feet and is a real nuisance to them eliminating the "hopping" around on the ledge or roost. Works great and is easily cleaned with mineral spirits. Does not harm birds. One 10 oz. tube will treat 10 linear feet. 

Eaton's 4 The Birds - Bird Repellent Gel Features:
* Leaves a clear odorless bead of gel
* Gel sticks to the birds' feet
* Eliminates the "hopping" around
* Works great !
* Easy clean up with mineral spirits
* Doesn't harm the birds

Eaton's 4 The Birds - Bird Repellent Gel Uses / Applications:
USE RESTRICTIONS: This product may be used to discourage pigeons and starlings, from roosting or perching on treated ledges, sills, roofs, peaks, cornices, and similar parts of municipal, industrial and commercial buildings, homes, apartment and condominium complexes, bridges and overpasses and similar structures.

EATON 4 THE BIRDS is a transparent, sticky product that remains tacky at 15 degrees F and will not run at temperatures up to 200 degrees F. Do not apply on location where desirable species of birds might become entangled in the repellent.

APPLICATION DIRECTIONS:
Surface Preparation: Clean surfaces to be treated to promote adhesion of repellent. Wipe or scrape all dust, dirt, droppings, and other loose debris from surfaces. Seal porous surfaces prior to treatment by brushing on one coat of shellac or a 50% solution of white glue, and allow to dry. Product Application: Use a caulking gun and/or a putty knife to apply this product. A properly applied bead of JT EATON 4 THE BIRDS BIRD REPELLENT looks like this (see Manual below) in cross section. Press against surface to ensure good adhesion. To treat ledges or sills, apply beads of repellent no larger than 1/2" wide by 1/2" deep at the deepest part in strips no closer than 2" apart, beginning 1" in from the outer edge. To treat roofs, peaks, cornices, etc., apply a single bead of repellent along the highest point. A second treatment may be necessary if product becomes flattened by heavy bird traffic.

DO NOT APPLY PRODUCT IN BEADS WIDER OR DEEPER THAN THAT PRESCRIBED ABOVE.

One 10 oz. tube of this product will treat 10 linear feet when product is applied in beads 1/2" wide and 1/2" high.
Partially Filled Cartridges: Replace cap on tip of tube.
Product Clean-up: Use mineral spirits to remove product from treated surfaces, equipment, or other contaminated articles.

Eaton's 4 The Birds - Bird Repellent Gel Target Pests:
Pigeons and starlings

Eaton's 4 The Birds - Bird Repellent Gel Active Ingredients:
Polybutene..................................93%

Eaton's 4 The Birds - Bird Repellent Gel EPA Reg. No. 8254-3-56

Eaton's 4 The Birds - Bird Repellent Gel Size: 10 oz, 1 each
Eaton's 4 The Birds - Bird Repellent Gel Category: Gel Repellent
Eaton's 4 The Birds - Bird Repellent Gel Manufacturer: J.T. Eaton & Co., Inc.